Description

All UNOKLIMA XT-U models are easy to install and very easy to maintain. A hole in the external wall and two wires, and you are almost done.

UNOKLIMA XT-U 100 models are only recommended for situations where it is impossible to install a 160 mm model, or where the aim is to upgrade an existing 100 mm air duct. In general, 100 mm models are not recommended for bedrooms.

UNOKLIMA XT-U BASE 100 provides continuous ventilation with heat recovery.

Reduces humidity, radon, viruses and CO₂. Effective ventilation with minimal heat loss and the windows closed—even while you are asleep or away from home. Open windows and conventional extraction result in substantial heat loss and increase the demand on the building’s heating system.

UNOKLIMA continuous ventilation with heat recovery minimises heat loss. This enables significant energy savings by preventing the heating system from having to operate at maximum output, as it would when ventilating by opening windows.

Ideal applications include private homes, holiday homes, offices, classrooms, site cabins, workshops and much more. Can be installed in external walls with a thickness of 250–500 mm. A 700 mm air duct is available as an optional extra. The XT-U series is not suitable for use in wet rooms.

The unit operates in a continuous cycle of 70 seconds of extraction followed by 70 seconds of air supply. During extraction, heat is absorbed from the stale air. During air supply, this heat is transferred to the incoming fresh air.

UNOKLIMA XT-U 100 is equipped with a heat exchanger. Under typical indoor and outdoor temperature conditions, average heat recovery of up to 79–83% is achieved when operating at speed 2.

The units have been tested in accordance with European standard EN1254:2014, which is used for comparison with other products. This EN test shows a maximum heat recovery efficiency of 93%, which is used for product comparisons.

The XT-U 100 model has the capacity to ventilate rooms of up to 20 m² when operating at the highest speed. Continuous operation at lower speeds produces less noise but also reduces ventilation capacity. Multiple units should be installed in larger rooms. When installing multiple units in the same room, there must be a minimum distance of 3 metres between them.

The XT-U 100 ASE model is supplied with a standard remote control for selecting between 3 speeds and stopping/starting the fan. The unit is switched on and off via the external power supply. The internal panel opens/closes after 40 seconds, depending on whether the unit is operating or switched off. The remote control has a stop/start button that stops/starts the fan without closing the front cover.

Maintenance: The heat exchanger, housing and filters must be maintained after every 3,000 hours of operation or every 3 months. Vacuum the heat exchanger and wash or replace the filters. Wipe the air duct, housing and fan blades with a dry cloth.